Skip to content
Search jobs inside ChatGPT or Claude. Claude, ChatGPT, Claude Code, Codex, Gemini, Cursor and Grok
Connect
All syllabi
BCSWritten

BCS written syllabus

General and technical cadres · 235 pages

Compulsory subjects and post-related subjects for professional and technical cadres. Confirm the applicable subject code in the recruitment notice.

Published by BPSC. Collected 2026-11-14. Confirm the edition and subject against your recruitment notice before studying.

Text below is extracted for search and may contain mistakes. Use the original PDF to check marks, formulas and Bangla spelling.

BanglaEnglishBangladesh affairsInternational affairsCivil engineeringElectrical engineeringMechanical engineeringComputer science

Read the document

Page 214 of 235

Searchable text (unverified)
SYLLABUS FOR BCS (WRITTEN) EXAMINATION     
       
214/235 
 
high speed relaying transmission lines, Operating characteristics of different types of 
relays: DMT and IDMT relays, Overcurrent relay, Directional relay, Differential relay, 
Impedance relay, Reactance relay, Mho relay, Modified impedance rel ay, Zero sequence 
and negative sequence relays, Balance current relaying of parallel line, Ground fault 
relaying, Pilot relaying principles, Carrier pilot relay, Apparatus protection, Circuits and 
relay setting, Generator and motor protection, Transformer protection, Busbar protection, 
Line protection, HVDC system protection.  
 
4. Power Plant Engineering 
Thermal, Steam, Hydroelectric barge mounted, Nuclear power plant load curves, 
Estimates of load, Load curves, Study and analysis of load curves, Interpretation of load 
curves, Determination of actual demand and capacity of various components in a system, 
Plotting the expected load curve of a system, Use of the load curves, Load growth and 
extrapolation of load curves, Selection of plant, Effect of variable load on power plant 
design, Continuity of service requirements and its effect on plant design, Cost 
consideration, Equations of performance for plant equipment and electric service, 
Selection of units, Standby units, Large and small units, Number and sizes of units, Plant 
location, Considerations for site selection for different types of plants, General 
considerations for different types of power plants: large, medium and small, conventional 
and nuclear. Introduction to Non -conventional Renewable Energy Conversion: Solar, 
Wind and wave electric energy converters.  
Renewable Energy : Wind turbine generators, Construction & basic characteristics of 
solar cells, Photovoltaic systems, Fuel cells, Hybrid systems, Tidal energy, Biogas & 
biomass energy. Economic marginal transmission cost, Graphical solution for location of 
different types of distribution, Rectangul ar distribution of loads, Economic conductor 
selection and general consideration, The ideal conductor, Effect of any deviation from the 
ideal cross -section, Limits for size of underground cables, Selection of ideal supply 
voltage, Plant performance and ope ration characteristics, Performance characteristics, 
Efficiency, Heat rate, Incremental rate method, Station performance characteristics, 
Station incremental rate, Capacity scheduling, Base load and peak load, Load division 
between steam and hydro stations , Bus system, Importance of power control, Current 
limiting reactors, Different types of bus system layouts, Forces on buses in the case of 
short circuits, Nuclear power stations, Comparison with conventional generation methods, 
Chain reactions, Moderators, Classification of reactors, Special power reactors, Shielding.